• Community support

  SNMP V2 trap alarm problem

  Posted by lnieminen on December 12, 2010 at 22:39

  Hi,

  I need to make an alarm based on trap OID and I have actually already managed to do that.
  The problem is that it is only possible to do this with SNMP V1 traps.
  Every time I get a V2 trap the IP is 0.0.0.0, OID is always cold start, value is N/A and the actual trap data is lumped to the “Custom” field and I cannot hook any alarms to OIDs contained within that field (see the attached picture; lower ones are V1 and upper ones are V2 traps).
  Any help would be much appreciated….

  

  lnieminen replied 14 years, 2 months ago 1 Member · 0 Replies
• 0 Replies

Log In to Reply