Recon Server not finding devices

[Mario]

Like it

Up

0

Down

Drop it

::

Hi

The problem is the Network configuration. If you need to recon the Network 192.168.254.X, you need you set this: 192.168.254.0/24. If you need the network 192.168.X.X ( 192.168.0.0/16).

Regards

[gabriel-m]

Like it

Up

0

Down

Drop it

::

i fixed the setting, yeah that was my bad but still cant find devices. the progress bar shows and stays in 1% at times and then after i refresh the page is done and nothing else happens

[Sancho]

Like it

Up

0

Down

Drop it

::

i fixed the setting, yeah that was my bad but still cant find devices. the progress bar shows and stays in 1% at times and then after i refresh the page is done and nothing else happens

Probably the recon server is stuck doing the recon, you need to refresh, and if cannot refresh, try restarting the server.

Anyway, be advised, running recon under vmware workstation, virtualbox and parallels sometimes report nasty reports. Using xen, or ESX works fine.

[gabriel-m]

Like it

Up

0

Down

Drop it

::

I refreshed the page after few minutes and the the recon tasked showed that it was done, then i restarted the server but it did the same, is not finding devices in the network

[Sancho]

Like it

Up

0

Down

Drop it

::

Reviewing your screenshot I found why.

You pick the OS to match to “Foundry”… this usually doesn’t work very well (it doesnt depend on pandora, the best OS fingerprinting tools have an important % of err), it works on some “basic” OS like Linux, Windows and Solaris, but not with network equipment, and if you’ve added your custom OS definitely it won’t work. Put there “Any” and you will see your network populated for sure.

[gabriel-m]

Like it

Up

0

Down

Drop it

::

Don Sancho you are a genious man, that work i found devices in the 10.0.90 network. Thank you so much.

[Sancho]

Like it

Up

0

Down

Drop it

::

Don Sancho you are a genious man, that work i found devices in the 10.0.90 network. Thank you so much.

Great ! 😉