Saludos! Estuve revisando el foro, y algunas personas han planteado este problema, pero no ha habido solución. Lo consulto nuevamente por si es que se hubiera detectado algo. Al momento de crear una Recon Task y configurar las opciones de Parent Detection (Activada) y Parent Recursion (5), la tarea funciona correctamente. Pero los agentes detectados no establecen relación de parentesco entre ellos y al momento de generar un Network Map, los muestra todos asociados a un solo nodo. ¿Alguien tiene alguna pista sobre esto? Cualquier ayuda es muy agradecida. Si se necesita que adjunte algún antecedente, favor avisar. ------------------------- o ----------------------------- Regards! I was reviewing the forum, and some people have raised this problem, but there has been no solution. I ask again if anything has been detected. When you create a Recon Task and configure the Parent Detection (enabled) and Parent Recursion (5) options, the task works correctly. But the detected agents do not establish the relation of parenthood between them and at the moment of generating a network map, the agents are associated to a single node. Does anyone have any clue about this? Any help is very grateful. If it is necessary to attach an antecedent, please advise.
[
](//pandorafms.com/community/media/forum/8598/21260=1077-Network-Map.JPG)
