Pandora FMS Community

How to validate events

taraska90 · 27 abr 2017, 16:35 · 2 mensajes · 57 visitas

  1. Inicio del debate

    Hello, For example, I have two snmp modules that check status of two Power Supply Unit on cisco device. When there is no power on one PSU corresponding module is triggered and the events created. But this events created each time when snmp poll occurs. And if I even validate that event after five minutes appears new event that replace old one. Okay... But if I disable this module,this event appears again! What can I do in this case?

    [

    ](//pandorafms.com/community/media/forum/8404/20778=1014-pandora1.png)

    [

    ](//pandorafms.com/community/media/forum/8404/20778=1013-pandora2.png)

  2. Hello taraska90, If you validate the event, it will appear again if the SNMP polling module gets a critical status agan, this is correct.  What is strange is this event appearing again even when the module is disabled.  These are the steps: 1. Module gets executed, collects data. 2. Based on the data collected and thresholds, goes critical. 3. Due to this module changing its status, a new event is generated. Note: when you disable a module, it doesn't get executed, so doesn't collect data. Knowing this, should not be possible that a new event is generated after disabling the module.  Once you've disabled the module, if you validate the next critical event, are new events generated or this happens only once? Kind regards, Antonio.

Entra en tu cuenta para publicar.