Pandora FMS Community

New install cant poll data from windows client

tripp · 30 abr 2014, 23:05 · 3 mensajes · 59 visitas

  1. Inicio del debate

    New install of Pandora FMS v5.0SP3 - Build PC140430 on centOS 6.5. followed install guide. and install of client on windows server 2012.  - edited conf on windows only changed the server IP - added an agent on pandora pointing to the windows server - no data from windows server showing up. - check firewalls are both off, sniff with tshark on linux and see the "tentacle" packets coming in and being replied to. but i dont see that port actively listening on linux server. I see the tentacle_server being referenced in the documentation but from following the install guide for centOS I do not have a binary for tentacle nor is it in the /etc/pandora_server/  conf file so assuming thats outdated documentation? - change windows host to ssh transfer_mode  (troubles finding any useful documentation on this and many areas of this monitoring solution) not sure what to set for auth? used the --test-ssh and it was successful but again still no data showing up in pandora console. - agent log file doesnt show any useful info at all, nor does the log and error file on the server. Am I wrong to assume that the modules defined in the default windows config should be sending data to the server? do i need to install this tentacle server daemon and if so how? wheres the doc on that? wheres the technical doc on how the agent sends data to the server via this 'tentacle' protocol and how to use ssh instead? I also added the WMI checks to this agent in pandora but not pulling any data from windows. i see pandora server connecting in netstat but still says no active monitors under the agent view. how to get this setup for a default install and where is some useful documentation on it.

  2. Hello Don't change the transmission protocol to ssh. We will guide through to find out why is this problem happening. First of all I need to know if this is the appliance cd instalation or is it an installation on a centos distribution? Regards Ivo

  3. You may just need to start the tentacle server.  (/etc/init.d/tentacle_serverd start if you are on Linux).  I ran into a similar issue setting Pandora FMS up the first time.  It wasn't clued in to why it wasn't working till I rebooted the server as part of our weekly maintenance, and everything sprung to life.

Entra en tu cuenta para publicar.