Hi all, yet there is something I miss in order to monitor through the usage of a monitor agent. Theoretically I should uncomment the right module config lines like the following # Get disk space free in MB module_begin module_name disk_root_free module_type generic_data module_exec df -kh / | tail -1 | awk '{ print 100-$5 }' module_max 100 module_min 0 module_description Free disk Percentage of root partition module_min_warning 70 module_max_warning 90 module_min_critical 91 module_max_critical 100 module_end then on the server through the GUI I should create a new "data server module" pay attention that the module name and the module type match the definitions as foubnd in the pandora_agent.conf and I should be OK. Most of the time what I get is a blue mark that means module "not init", then I do something (deleting the module, re-adding it and other stuff) then if I'm lucky I get the green mark but recently I get a grey mark. I took captures on the client and I see that the XML file is sent to the correct IP address of the server (all is within the same LAN, no device or firewalls in the middle). On the server side I checked the directories /var/log and /var/log/pandora but I cannot find any log file update up to the current date. I compared the configuration of other modules that collect data and it seems the new modules are set in the same way. What are the simplest steps to have the server collect the info from the client? Where to check if the XML file sent by the client is parsed but errors are seen (for instance)? Sorry for the very basic questions but whenever I have to monitor new parameters from a client I always struggle with this process. If it is of interest, the client was renamed from within the GUI interface and then new data server module were added. Thanks in advance, Alex
Inicio del debate
