hi, I'm learning how to configure the Pandora FMS and I have a doubt, it should be fairly simple. I have some computers that I'm doing a "host alive" and being "boolean data" shows the critical condition but I wanted to show the warning condition How should I proceed to setup? Sorry my english is not the best
ICMP Check
sensemaker · 24 jun 2013, 19:53 · 12 mensajes · 66 visitas
- Inicio del debate
Hello This is the proper setting: warning min - -0.5 warning max -- 0.5 critical min -- 0.6 critical max ---0.8 Best Regards
thanks for the help, but I think I explained badly. what I want is not critical but the alert warnings. I set the warning min 0 max 1 but is always critical
Have you tested this configuration? warning min - - 0.5 warning max -- 0.5 critical min -- 0.6 critical max ---0.8 when a boolean module is not woks fine, the value is 0, when works fine is 1. You must configured warning values from (-0.5) to (0.5) Best regards
yes tested it, but when I save and return to open the module, the values return to 0
What Pandora version are you using?
pandorafms_console-4.1RC2-130623, but the original is 4.0.3
If you create a new module with this configuration. Neither upload this values?
yes the values is 0, but if I insert 1,2,3,4,5, n values are recorded, only the 0.n does not record
Hi, check this config with Pandora 4.1 version. Regards
[

](//pandorafms.com/community/media/forum/0/15284=469-ping1.png)
[

](//pandorafms.com/community/media/forum/0/15284=470-ping2.png)
Thanks, but if you configure the module in the device it assumes the values, but if you try to edit directly on the module no longer works
[

](//pandorafms.com/community/media/forum/0/15291=472-prob1.png)
[

](//pandorafms.com/community/media/forum/0/15291=473-prob2.png)
Thanks for report. Yes, this is a bug, we are going to repair it to Pandora 4.1 final. Thanks again
Entra en tu cuenta para publicar.




