Parameters

"address" Host or ip of the switch to which you want to connect.
"username" User
"password"

Password. In case you need to enable password, specify separating password and enable with "/" : password/enable.

Example : P4nd0r4/S3uK!

"command" Command to be executed on the target machine
"extra_command" In case paging is required (the output is shown cut off), use this parameter to launch a command to enable paging mode.
"--debug" To display extra run information

Revision #3
Created 22 November 2023 17:10:40 by alejandro.sanchez
Updated 14 December 2023 14:11:01 by alejandro.sanchez