Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Recon task not discovering IPs if IPs don't start at the beginning of subnet
Has anyone else run into this problem?
The recon task does fine discovering IP devices if they start at the beginning of a subnet.  x.x.x.1, x.x.x.2 etc.
But if there are no IPs until x.x.x.150, x.x.x.151, then the devices will not get discovered unless I change the subnet to get the IPs to start at the beginning of the subnet.

Any fixes for this?

thx  dj
upgraded to 7.0NG and it works much better.

Users browsing this thread: 1 Guest(s)

(c) 2006-2018 Artica Soluciones Tecnológicas. Contents of this wiki are under Create Common Attribution v3 licence. | |

Theme © MyBB Themes