Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Recon task not discovering IPs if IPs don't start at the beginning of subnet
#1
Has anyone else run into this problem?
The recon task does fine discovering IP devices if they start at the beginning of a subnet.  x.x.x.1, x.x.x.2 etc.
But if there are no IPs until x.x.x.150, x.x.x.151, then the devices will not get discovered unless I change the subnet to get the IPs to start at the beginning of the subnet.

Any fixes for this?

thx  dj
 Reply


Users browsing this thread: 1 Guest(s)


(c) 2006-2018 Artica Soluciones Tecnológicas. Contents of this wiki are under Create Common Attribution v3 licence. | pandorafms.com | pandorafms.org

Theme © MyBB Themes