graphing minus values in pandorafms

  • graphing minus values in pandorafms

    Posted by helplakmal on September 24, 2013 at 13:21

    hi!!

    I’m using pandorafms for monitor ubiquity devices these days. but I faced a problem with graphs. I got graphs for most of the parameters like (wlanRxBytes,CCQ,…) but “Signal” or “Noise Floor” didn’t generate any graph. I think problems in graphing function/s in pandorafms. they only support plus values not for minus values. I think convert minus values to plus values is not a good option because it can mislead and give wrong picture about the situation. I think this is a problem that can occur in future for other users. I think you should consider about this.

    Regards

    helplakmal replied 11 years ago 2 Members · 4 Replies
  • 4 Replies
  • Mario

    Member
    October 4, 2013 at 16:43
    1147 Karma points
    Community rank: tentacle_master_icon Tentacle Master
    Like it
    Up
    0
    Down
    Drop it
    ::

    Hi

    Could you report me a screenshot with data and the graph example?

    Thanks

  • helplakmal

    Member
    October 8, 2013 at 09:53
    0 Karma points
    Community rank: tentacle-noob-1 Tentacle noob
    Like it
    Up
    0
    Down
    Drop it
    ::

    This device is a Rocket device. it gives signal and noise floor as minus values. i add these data to system using xml files. attached files are showing graph and data for “Signal” parameter. I think improving graphing functions to view both plus values and minus values could be useful for future.

  • Mario

    Member
    October 8, 2013 at 14:48
    1147 Karma points
    Community rank: tentacle_master_icon Tentacle Master
    Like it
    Up
    0
    Down
    Drop it
    ::

    Thanks

    Will be repaired in the final release.

    Regards

  • helplakmal

    Member
    October 8, 2013 at 15:28
    0 Karma points
    Community rank: tentacle-noob-1 Tentacle noob
    Like it
    Up
    0
    Down
    Drop it
    ::

    thanks