Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
pandorafms applicance not working after install
After doing an install n the vm.

I get a license popup.  I perform the mv the enterprise directory as stated in the popup.
I then can get in the web interface.

Skipping the section 2.3 & 2.4

Performing section 3
It shows discovery Server is disabled.
Going to the server section I see all a popup showing ll servers are down.
It tells me to start the server but it will not start and state there is a license issue.

Not sure where to go from here.
I thought the appliance would be easy to setup but I messed it up somewhere.
Please advise.


Beginning to think the appliance will not run as a server without an enterprise license.
Good morning

Are you trying to install an enterprise version? The enterprise version requires a paid license to work. I would like to know where you got the packages you are using, because they should not be public, because they do not serve to perform an open installation.

In any case I recommend you to install with the sourceforge packages I leave you below.


Users browsing this thread: 1 Guest(s)

(c) 2006-2018 Artica Soluciones Tecnológicas. Contents of this wiki are under Create Common Attribution v3 licence. | |

Theme © MyBB Themes