Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
SNMP module not initializing
#1
Hello!

I have Pandora 3.1 installed, with only one agent added yet. So far I created the agent (a switch) and added a network module to get information about the network flow of one specific port. I entered all the data, did an SNMPWALK and chose "ifInOctets" and clicked on "save".

But the module is not initializing, I still see a yellow exclamation mark. But why? The SNMPWALK did work, it also showed the data. What could be the problem?

I tried another server, also with ifInOctets, but also no luck... thanks for any help!

regards, JPSelter
 Reply
Messages In This Thread
SNMP module not initializing - by JPSelter - 09-07-2010, 01:06 PM
Re: SNMP module not initializing - by JPSelter - 09-08-2010, 09:07 AM


Users browsing this thread: 1 Guest(s)


(c) 2006-2018 Artica Soluciones Tecnol├│gicas. Contents of this wiki are under Create Common Attribution v3 licence. | pandorafms.com | pandorafms.org

Theme © MyBB Themes